Prefabrication and Panelised Structures

Robertson House

Queens Rd Website

Hill Top Harbour Views

 

The Design

The Robertson House was designed by Red Box and built by J. Stewart Builders using Potius floor, wall and roof panels built in our factory.  A simple 3 level design with mono pitch roofs built on a steep site with no off street space for materials or a crane.  On this job we managed all the logistics for traffic control, transport and Hiab and successfully erected the structure with a 4 man team in 3 days.

 Queens Rd 1 Website   Living Space

                                      Internal View    Queens Rd 2 Website

Queens Rd 5 Website  Western Elevation

                            Southern Elevation    Queens Rd 4 Website

Site Work

Day one on Robertson started with setting up traffic control thanks to Craig at Asphalt and General and getting the Lift and Shift hiab in place, after a team meeting with Jason Stewart and his team work began on placing panels at 9:30 am.

Day one saw the lower floor and walls and the mid level floor in place.

IMG 6317  IMG 6337  IMG 6338  IMG 6339  IMG 6340  IMG 6341

Day 2 had an early finish once mid level walls and upper level floor were in place so we could mark out for upper floor walls and get set up to receive roofs for the lower levels.

IMG 6351  IMG 6353 Adjusted  IMG 6354 adjusted

Day 3 was going to be massive with upper level walls and 3 roofs to install on the last day of our road closure permit but good coordination of panel deliveries and a couple of extra sets of hands pulled from the factory everything was completed by 5pm.

IMG 6357  IMG 6358  IMG 6361  IMG 6364  IMG 6369 Adjusted  IMG 9929  IMG 9933